When machining a long piece of work between...

Question 1 / 270705eccef9bbacbc34ba4d452c5

Question 1 of 270705eccef9bbacbc34ba4d452c5

When machining a long piece of work between centers, you must __________.

Question 1 of 27070

When machining a long piece of work between centers, you must __________.

🔍 Key Concepts

• Work between centers requires support from both headstock and tailstock centers • Function of a lathe dog and faceplate when driving work held between centers • Effect of thermal expansion and tailstock pressure on long workpieces

💭 Think About

• In normal between-centers turning, what actually drives the work to rotate, and how is that safely transmitted? • What can happen to a long, slender workpiece if the tailstock is forced tightly against it while it heats up and expands? • Which option describes a condition that is safe and typical for between-centers work, rather than an extreme or incorrect setup?

✅ Before You Answer

• Verify how the lathe dog should fit into the faceplate slot (rigidly jammed, or engaged with some clearance?). • Check whether the work should be supported by one center or both when it is long and run between centers. • Consider whether the tailstock should be forced tight against the work or adjusted to avoid excessive end pressure as the work heats and grows.

Question 1 of 27070

When machining a long piece of work between centers, you must __________.

make sure that the lathe dog is securely jammed in the slot of the face plate

correct for expansion of the work by readjusting the tailstock center

make sure that the work is only supported by the headstock center

make sure the tailstock is tight against the work

Question 1 / 270705eccef9bbacbc34ba4d452c5

Question 1 of 270705eccef9bbacbc34ba4d452c5

When machining a long piece of work between centers, you must __________.

Back

Question 1 of 27070

When machining a long piece of work between centers, you must __________.