Which illustrated device would be best...

Study

Question 1 of 205eccefa5bacbc34ba4d4871b

Which illustrated device would be best suited for measuring the flow rate of wet gases using a primary, differential pressure, flow element? See illustration GS-0126.

Back

Question 1 of 20

5eccefa5bacbc34ba4d4871b

Which illustrated device would be best suited for measuring the flow rate of wet gases using a primary, differential pressure, flow element? See illustration GS-0126.

No comments yet

Be the first to share your thoughts!

If the question has a related picture, it will appear here.

🔍 Key Concepts

• Compare how orifice plates, flow nozzles, and Venturi tubes create differential pressure to measure flow. • Think about where liquid droplets/condensate in a wet gas will tend to collect inside each device. • Consider which device allows the liquid phase to pass through smoothly with minimal pooling and still gives a stable differential pressure signal.

💭 Think About

• In a horizontal run with wet gas, if liquid collects at the restriction or taps, how will that affect the accuracy of the differential pressure reading? • Looking at Figures A, D, and E, which internal shape is most self‑draining and least likely to trap liquid at the throat or at the pressure taps? • Which of these devices is generally preferred in industry for mixed‑phase (gas with some liquid) service when using differential pressure flow measurement?

✅ Before You Answer

• Verify which figure shows a sharp‑edged orifice plate versus a streamlined nozzle versus a Venturi tube. • Check where the pressure taps are located in each design and whether trapped liquid could bridge the high‑ and low‑pressure sides. • Confirm which device is known for handling wet/dirty flows better and for having lower permanent pressure loss.

👋 Hi! I'm Genie, your AI study assistant. How can I help you with this question?

Quick actions

— No credit card needed

Study

Question 1 of 205eccefa5bacbc34ba4d4871b

Which illustrated device would be best suited for measuring the flow rate of wet gases using a primary, differential pressure, flow element? See illustration GS-0126.

Back

Question 1 of 20

5eccefa5bacbc34ba4d4871b

Which illustrated device would be best suited for measuring the flow rate of wet gases using a primary, differential pressure, flow element? See illustration GS-0126.

No comments yet

Be the first to share your thoughts!

If the question has a related picture, it will appear here.

🔍 Key Concepts

💭 Think About

✅ Before You Answer

👋 Hi! I'm Genie, your AI study assistant. How can I help you with this question?

Quick actions

— No credit card needed