When using an analog multimeter set up as an...

Study

Question 1 of 205eccefa3bacbc34ba4d47f5d

When using an analog multimeter set up as an ohmmeter for resistance measurements, it should be calibrated by clipping the loose ends of the leads together followed by what procedure?

Back

Question 1 of 20

5eccefa3bacbc34ba4d47f5d

When using an analog multimeter set up as an ohmmeter for resistance measurements, it should be calibrated by clipping the loose ends of the leads together followed by what procedure?

No comments yet

Be the first to share your thoughts!

If the question has a related picture, it will appear here.

🔍 Key Concepts

• Ohmmeter zeroing procedure before taking resistance measurements • What the meter reads when the two test leads are shorted together • Difference between zero ohms and infinite resistance on an analog scale

💭 Think About

• When you clip the two ohmmeter leads together, what resistance are you telling the meter to expect? • On an analog ohms scale, is "zero" on the left or on the right side of the scale, and what does the pointer have to do before you measure any unknown resistance? • Which of the choices actually changes the meter’s internal setting so that it reads correctly with the leads shorted?

✅ Before You Answer

• Verify what the correct reading should be when the test leads are shorted together on an ohmmeter • Check which option is a normal front-panel adjustment found on an analog multimeter in the ohms position • Eliminate any answers that involve equipment or adjustments not normally required just to prepare an ohmmeter for use

👋 Hi! I'm Genie, your AI study assistant. How can I help you with this question?

Quick actions

— No credit card needed

Study

Question 1 of 205eccefa3bacbc34ba4d47f5d

When using an analog multimeter set up as an ohmmeter for resistance measurements, it should be calibrated by clipping the loose ends of the leads together followed by what procedure?

Back

Question 1 of 20

5eccefa3bacbc34ba4d47f5d

When using an analog multimeter set up as an ohmmeter for resistance measurements, it should be calibrated by clipping the loose ends of the leads together followed by what procedure?

No comments yet

Be the first to share your thoughts!

If the question has a related picture, it will appear here.

🔍 Key Concepts

💭 Think About

✅ Before You Answer

👋 Hi! I'm Genie, your AI study assistant. How can I help you with this question?

Quick actions

— No credit card needed