What problem with a printed circuit board...

Question 1 / 2707066636eed28f7522a1c51d91f

Question 1 of 2707066636eed28f7522a1c51d91f

What problem with a printed circuit board may resolve itself once a board is removed from its edge card connector and then reinstalled?

Back

Question 1 of 27070

What problem with a printed circuit board may resolve itself once a board is removed from its edge card connector and then reinstalled?

🔍 Key Concepts

• Intermittent connections caused by vibration or poor seating • Differences between issues that are temporary vs. permanent damage on a PCB (printed circuit board) • How re-seating a board affects electrical contact at the connector pins

💭 Think About

• Which of these problems could be temporarily fixed just by improving physical contact between the board’s edge and the connector? • Which options describe permanent physical damage or deterioration that would NOT fix itself simply by removing and reinstalling the board? • Think about what vibration, oxidation, or slight misalignment at the connector might cause—and what a simple re-seating could clear up.

✅ Before You Answer

• Eliminate any choice that involves permanent physical damage to the board or components. • Ask: Which issue is most likely to be intermittent and depend on how well the board is seated in the connector? • Confirm which problem could be affected by movement/cleaning action when you pull out and reinsert the board.

Question 1 of 27070

What problem with a printed circuit board may resolve itself once a board is removed from its edge card connector and then reinstalled?

Corroded pin connectors

Discolored or darkened components

Leaking components

Open traces or broken connections

Question 1 / 2707066636eed28f7522a1c51d91f

Question 1 of 2707066636eed28f7522a1c51d91f

What problem with a printed circuit board may resolve itself once a board is removed from its edge card connector and then reinstalled?

Back

Question 1 of 27070

What problem with a printed circuit board may resolve itself once a board is removed from its edge card connector and then reinstalled?