Operating the compressor and motor as shown...

Question 1 / 270705eccefa1bacbc34ba4d471db

Question 1 of 270705eccefa1bacbc34ba4d471db

Operating the compressor and motor as shown in figure 5 of the illustration, will result in ________. See illustration GS-0159.

Back

Question 1 of 27070

Operating the compressor and motor as shown in figure 5 of the illustration, will result in ________. See illustration GS-0159.

If the question has a related picture, it will appear here.

🔍 Key Concepts

• V-belt drive alignment – look at how the pulley centers line up in Figure 5 compared to a correct installation (Figure 3). • Effect of parallel misalignment on belts vs. pulleys vs. shafts – which part is normally sacrificed first? • Difference between axial load on shafts and belt life/wear when a belt is forced to run out of line.

💭 Think About

• In Figure 5, are the pulley faces parallel, or are they tilted? Are their centerlines in the same plane, or offset? What kind of misalignment is that called? • When a V-belt runs at an angle between two sheaves, does that tend to increase or decrease side loads on the shafts? And which component is designed to be cheaper and easier to replace – the belts or the pulleys/shafts? • Think about routine maintenance: when mechanics see this kind of misalignment, what failure or symptom usually shows up first in service?

✅ Before You Answer

• Confirm whether Figure 5 shows angular misalignment or parallel (offset) misalignment of the sheaves. • Decide which direction axial load on the shafts would realistically go with this misalignment – increasing or decreasing. • Ask: in standard belt-drive practice, misalignment like this is most commonly associated with what specific type of premature failure in the drive system.

Question 1 of 27070

Operating the compressor and motor as shown in figure 5 of the illustration, will result in ________. See illustration GS-0159.

severely damaging the V-grooves of the pulley

a decrease in the axial load on the crankshaft

a decrease in the axial load on the motor shaft

a decrease in the normal life of the drive belts

Question 1 / 270705eccefa1bacbc34ba4d471db

Question 1 of 270705eccefa1bacbc34ba4d471db

Operating the compressor and motor as shown in figure 5 of the illustration, will result in ________. See illustration GS-0159.

Back

Question 1 of 27070

Operating the compressor and motor as shown in figure 5 of the illustration, will result in ________. See illustration GS-0159.

If the question has a related picture, it will appear here.