One is informed by the owner that two of the...

Question 1 / 205eccef9bbacbc34ba4d45499

Question 1 of 205eccef9bbacbc34ba4d45499

One is informed by the owner that two of the vessel's electrically driven centrifugal cooling water pumps will be replaced with two of higher capacity pumps. No modification of existing piping will be involved. What should be your concerns from an operational perspective?

Back

Question 1 of 20

5eccef9bbacbc34ba4d45499

No comments yet

Be the first to share your thoughts!

If the question has a related picture, it will appear here.

🔍 Key Concepts

• Pump capacity vs. system design limits – what happens to flow rate, velocity, and pressure when you increase pump size • Electrical loading and protection – circuit breakers, controllers, motor starters, and cable sizing when motor HP (horsepower) increases • Erosion and wear in piping systems – relationship between fluid velocity and erosion/corrosion in discharge lines

💭 Think About

• If you increase the pump capacity but do NOT change the piping, how will the flow velocity and resulting stresses in the piping change? • How do motor size and pump capacity affect the sizing of circuit breakers, overloads, and controllers? Are they always built with enough extra margin? • Which answer choices assume that existing designs always have enough safety margin, and is that a safe operational assumption?

✅ Before You Answer

• Check whether higher capacity pumps usually draw more electrical power and what that implies for breaker and controller ratings • Consider whether increased flow in the same size piping leads to higher velocity and the potential for erosion or water hammer • Look for the option that recognizes specific new risks (electrical and mechanical) rather than assuming “no concern” due to generic safety factors

👋 Hi! I'm Genie, your AI study assistant. How can I help you with this question?

Quick actions

— No credit card needed

Question 1 of 20

Upgrading of circuit breakers and controllers and possible increased erosion of discharge piping due to increased system velocities.

Piping should be of no concern since it is designed with a safety factor. Electrical power should be of concern.

Electrical power should be of no concern due to safety margins designed into power systems. Increased erosion may be a long term consideration.

One should not be concerned operationally since all systems are designed with future modifications/upgrades in mind.

Question 1 / 205eccef9bbacbc34ba4d45499

Question 1 of 205eccef9bbacbc34ba4d45499

Back

Question 1 of 20

5eccef9bbacbc34ba4d45499

No comments yet

Be the first to share your thoughts!

If the question has a related picture, it will appear here.

🔍 Key Concepts

💭 Think About

✅ Before You Answer

👋 Hi! I'm Genie, your AI study assistant. How can I help you with this question?

Quick actions

— No credit card needed