Long horizontal sections of waveguides are...

Question 1 / 27070tApF74qDqctJmdhVQIiC

Question 1 of 27070tApF74qDqctJmdhVQIiC

Long horizontal sections of waveguides are not desirable because:

Question 1 of 27070

Long horizontal sections of waveguides are not desirable because:

🔍 Key Concepts

• Behavior of moisture and condensation in long metal tubes or enclosures • What happens to mechanical support and straightness over long horizontal runs • How RF waveguides are usually installed on ships (routing, supports, drainage)

💭 Think About

• Think about which issue is most likely to slowly build up over time in a long, sealed, horizontal metal passageway. • Consider what ship motion (pitch/roll) and weather might introduce into any long horizontal section of metal piping or waveguide. • Ask yourself which option would be a primary design concern that installers try to prevent with slight slopes or drains.

✅ Before You Answer

• Which choice describes a problem that can be prevented by adding a small slope instead of keeping the run perfectly horizontal? • Which problem would be a chronic maintenance and reliability concern in a marine environment? • Eliminate any options that sound more like theoretical RF concerns rather than practical installation issues for long horizontal runs.

Question 1 of 27070

Long horizontal sections of waveguides are not desirable because:

Moisture can accumulate in the waveguide.

The waveguide can sag, causing loss of signal.

Excessive standing waves can occur.

The polarization of the signal might shift.

Question 1 / 27070tApF74qDqctJmdhVQIiC

Question 1 of 27070tApF74qDqctJmdhVQIiC

Long horizontal sections of waveguides are not desirable because:

Back

Question 1 of 27070

Long horizontal sections of waveguides are not desirable because: