In the illustrated drawing, the feature...

Question 1 / 270705eccef9abacbc34ba4d45076

Question 1 of 270705eccef9abacbc34ba4d45076

In the illustrated drawing, the feature indicated by the measurement 1/8" is an example of __________. See illustration GS-0016.

Back

Question 1 of 27070

In the illustrated drawing, the feature indicated by the measurement 1/8" is an example of __________. See illustration GS-0016.

If the question has a related picture, it will appear here.

🔍 Key Concepts

• Radius – a dimension that applies to a curved (arc) surface from a center point • Chamfer – a beveled, straight-edge cut usually given in angle and length (e.g., 45° x 1/8") • Taper vs. straight surfaces – taper changes diameter gradually along the length, while a constant cylinder does not

💭 Think About

• Look closely at where the 1/8" arrow actually touches the part. Is it pointing to a curved surface or a straight, angled surface? • Compare the 1/8" callout to the nearby 45° dimension. Which feature looks like a chamfer, and which looks like something else? • Ask yourself: does the 1/8" describe how much the diameter is shrinking along the shaft, or does it describe a small rounding or bevel at an edge?

✅ Before You Answer

• Verify whether the leader line for 1/8" ends on an arc (curved corner) or on a flat, angled face. • Check if the drawing uses the letter R anywhere near the 1/8" dimension; this usually indicates a specific geometric type of feature. • Confirm that no gradual change in thickness or diameter over a length (a true taper) is being dimensioned by that 1/8" value.

Question 1 of 27070

In the illustrated drawing, the feature indicated by the measurement 1/8" is an example of __________. See illustration GS-0016.

camber

radius

taper

chamfer