In damage control, a flat block placed at...

Question 1 / 270705eccef9fbacbc34ba4d46a2e

Question 1 of 270705eccef9fbacbc34ba4d46a2e

In damage control, a flat block placed at the end of a shore for the purpose of distributing pressure is referred to as a __________.

Back

Question 1 of 27070

In damage control, a flat block placed at the end of a shore for the purpose of distributing pressure is referred to as a __________.

🔍 Key Concepts

• Shoring terminology used in damage control for supporting bulkheads and decks • Difference between a shore, a strongback, and end fittings that spread out the load • How pressure from a shore is transferred to the surrounding structure to prevent further damage

💭 Think About

• Which part of a shoring setup is actually in contact with the damaged surface and needs to spread the force over a wider area? • Among the terms given, which one is most closely associated with being a flat piece attached to the end of a shore rather than along its length? • Think about what would happen if the end of a shore pressed directly on a weak or damaged area without any flat piece—what component is used to avoid that?

✅ Before You Answer

• Identify which option specifically describes an end fitting for a shore, not a reinforcing member along its length. • Eliminate any term that usually refers to a long member used to tie or stiffen multiple shores together. • Confirm which term in damage control manuals is defined as a flat block that spreads the load at the contact point.

Question 1 of 27070

In damage control, a flat block placed at the end of a shore for the purpose of distributing pressure is referred to as a __________.

strong back

butt piece

stiffener

cradle