How should the filter bandwidth of a...

Question 1 / 27070fhZgQCKYtw44hy5Ingni

Question 1 of 27070fhZgQCKYtw44hy5Ingni

How should the filter bandwidth of a receiver IF section compare with the bandwidth of a received signal?

Question 1 of 27070

How should the filter bandwidth of a receiver IF section compare with the bandwidth of a received signal?

🔍 Key Concepts

• Intermediate frequency (IF) filters and how they shape the received signal • Relationship between filter bandwidth and signal bandwidth for avoiding distortion and limiting noise • Trade-off between too narrow and too wide a filter in radio receivers

💭 Think About

• If the filter is narrower than the signal bandwidth, what happens to parts of the signal (e.g., sidebands)? • If the filter is much wider than the signal bandwidth, what happens to the amount of noise entering the receiver? • In a well-designed receiver, should the IF filter pass only the signal, or the signal plus a lot of extra spectrum?

✅ Before You Answer

• Compare each choice with the idea that the filter should pass all essential parts of the signal without cutting them off. • Think about which option best limits noise while still passing the full signal. • Eliminate any options where the filter is clearly too narrow (cuts off signal) or unnecessarily wide (admits excess noise).

Question 1 of 27070

How should the filter bandwidth of a receiver IF section compare with the bandwidth of a received signal?

Slightly greater than the received-signal bandwidth.

Approximately half the received-signal bandwidth.

Approximately two times the received-signal bandwidth.

Approximately four times the received-signal bandwidth.

Question 1 / 27070fhZgQCKYtw44hy5Ingni

Question 1 of 27070fhZgQCKYtw44hy5Ingni

How should the filter bandwidth of a receiver IF section compare with the bandwidth of a received signal?

Back

Question 1 of 27070

How should the filter bandwidth of a receiver IF section compare with the bandwidth of a received signal?