For proper support when turning a long thin...

Question 1 / 270705eccef9bbacbc34ba4d452c3

Question 1 of 270705eccef9bbacbc34ba4d452c3

For proper support when turning a long thin piece of work between lathe centers, you should use a __________.

Question 1 of 27070

For proper support when turning a long thin piece of work between lathe centers, you should use a __________.

🔍 Key Concepts

• Support of long, slender workpieces on a lathe • Difference between work-holding devices (that grip/drive the work) and support devices (that prevent bending or vibration) • Purpose of a steady rest versus a lathe center or chuck

💭 Think About

• Which device is specifically designed to prevent a long, thin shaft from whipping or bending in the middle while it rotates? • Which options are mainly used to hold or drive the work at the headstock, rather than to support it along its length? • Think about where along the workpiece the support is needed: only at the ends, or also somewhere in the middle?

✅ Before You Answer

• Identify which option is used to support the work between centers along its length, not to drive it. • Eliminate any option that is primarily a work-holding or mounting device at the headstock (for example, for disks or short work). • Confirm that your choice is commonly used with long, slender shafts to reduce vibration and deflection during turning.

Question 1 of 27070

For proper support when turning a long thin piece of work between lathe centers, you should use a __________.

faceplate

steady rest

draw-in collet chuck

compound rest