During repairs it is necessary to replace an...

Question 1 / 270705eccef9cbacbc34ba4d45bf4

Question 1 of 270705eccef9cbacbc34ba4d45bf4

During repairs it is necessary to replace an existing vessel bulkhead. Drawings indicate it is a "B" class bulkhead. This indicates which of the following?

Back

Question 1 of 27070

During repairs it is necessary to replace an existing vessel bulkhead. Drawings indicate it is a "B" class bulkhead. This indicates which of the following?

🔍 Key Concepts

• Class A vs Class B bulkheads in SOLAS / 46 CFR for fire protection • Difference between flame passage and smoke passage requirements • Standard fire test time ratings (in minutes) for structural divisions

💭 Think About

• First, recall what the main purpose of a Class B bulkhead is compared with a Class A bulkhead. Is it primarily structural, insulation-related, or flame-containment? • Think about the typical time ratings used in marine fire protection (e.g., 15, 30, 60, 120 minutes). Which of these are usually associated with lighter divisions like Class B, and which are for heavier, main fire boundaries? • Look closely at which options mention smoke as well as flame. Does the Class B definition focus on smoke, flame, or both?

✅ Before You Answer

• Verify the official definition of Class B divisions in SOLAS Chapter II-2 or 46 CFR fire protection sections before choosing. • Check whether Class B bulkheads are required to prevent smoke passage specifically, or only flame passage. • Confirm the exact test duration (in minutes) for the standard fire test applied to Class B bulkheads.

Question 1 of 27070

During repairs it is necessary to replace an existing vessel bulkhead. Drawings indicate it is a "B" class bulkhead. This indicates which of the following?

"B" class bulkheads must not allow flame or smoke passage for 15 minutes when subjected to a fire test.

"B" class bulkheads must not allow flame passage for 30 minutes when subjected to a fire test.

"B" class bulkheads must not allow flame passage for 60 minutes when subjected to a fire test.

"B" class bulkheads must not allow flame passage for 120 minutes when subjected to a fire test.

Question 1 / 270705eccef9cbacbc34ba4d45bf4

Question 1 of 270705eccef9cbacbc34ba4d45bf4

During repairs it is necessary to replace an existing vessel bulkhead. Drawings indicate it is a "B" class bulkhead. This indicates which of the following?

Back

Question 1 of 27070

During repairs it is necessary to replace an existing vessel bulkhead. Drawings indicate it is a "B" class bulkhead. This indicates which of the following?